General Questions

What care should be taken with TMP System?

The care that must be taken are:

• Do not exceed the maximum voltage, current and operating temperature.
• Although the inputs and outputs of the TMP System are protected against voltage surges , it is necessary in any installation to verify that the voltages and currents are adequate.
• Avoid simple version of the System Board TMP use metal elements above or below, they can make short circuits or accumulate temperature. The distance to the next metal or non-metallic element is 10 cm.
• The most important connection is the power supply , which should not be interrupted as it can generate failure cases monitoring applications that are loaded or stored in ROM parameters.
• The System Board TMP must be properly supported by six bolts for proper torque at its terminals and efforts not subject not calculated surface components.
• The System Board TMP design have isolated supplies making the best use of analog - digital converters DAC and isolation of land in the steps of power and signal. For this reason it should properly identify the land at the time of connection for the best quality in the digitization of the data.
• The System Board TMP was designed under usability concepts so that the user does not make mistakes during installation and configuration.

Can I work the DEMSW system in parallel with the XDECT16.EXE system?

If possible and corresponds to a redundant acquisition and seismic traces that would be acquired in the two systems while.

© Copyright 2013 - 2019 Schüler Weage Investigative Electronics.

All Rights Reserved